Ender 5 LED Strip Holders 3D Printer Model
The file 'Ender 5 LED Strip Holders 3D Printer Model' is (stl) file type, size is 1.7MB.
The file 'Ender 5 LED Strip Holders 3D Printer Model' is (stl) file type, size is 1.7MB.
A pair of holders for 30cm LED strips (10mm wide)
One for the front with 10 degree angle down, and the one in the back has a 66 degree angle so it doesn´t shine straight in your face.
They are both split in two parts which snap together with some glue. (Couldn´t fit them on the printbed)
Mount with T-nuts and short M3 screws
Print the front holders with support and the back without
Edit: I noticed that my Front LED holder was getting a little bent, not being 100% straight in the joint. Therefore I made a small add-on. A third mount that fits perfectly in the center. IF this happens to you as well, there´s no need to re-print, just add this small piece ("xtraholder.stl")| LEDbar-Back_1.stl | 3.5MB | |
| LEDbar-Back_2.stl | 3.4MB | |
| LEDbar-Front-xtraholder.stl | 60.3KB | |
| Led_Frontv3-1.stl | 1.0MB | |
| Led_Frontv3-2.stl | 1.0MB |
