Ender 3 V3 SE Screen Panel Holder With Filament-Hose Holder 3D Printer Model
The file 'Ender 3 V3 SE Screen Panel Holder With Filament-Hose Holder 3D Printer Model' is (stl) file type, size is 744.9KB.
The file 'Ender 3 V3 SE Screen Panel Holder With Filament-Hose Holder 3D Printer Model' is (stl) file type, size is 744.9KB.
"Remix" is a little exaggerated as i only "drilled" a forth hole in it to hold a teflon hose for guiding the filament from the front to the back.
Fix the Pipe Holder with a M3x8 screw to the Display Holder
I use this part here in combination with the Z axis gantry mounted tube guide (https://www.thingiverse.com/thing:6703273) and the ptfe tube mount with filamant runout sensor (https://www.thingiverse.com/make:1184389).
I need this for my personal setup where my printer stands on a long Ikea Lack table and my filament box stands in front of it on the floor.
Addionally i re-created my Ikea Lack Housing (still in progress), as my new printer is much higher then my old one.
UPDATE July 24th 2024
I changed the Pipe Holder a little. Now you can't pull the tube thru its holder when pulling the filament out.
OK, inserting is a little more tricky now.
UPDATE July 26th 2024
I'm using an Ikea Lack Housing with a filament passage thru the front right leg. The filament was bend to much, therefore i replaced the Pipe Holder with Front Pipe Guide bended.
The hose goes thru the whole passage and the filament won't be bend too much.
If you're not using a housing similar to mine you can still use the original Pipe Holder.
| Display_Holder_for_Pipe_Holder_3.stl | 465.4KB | |
| Front_Pipe_Guide_bended.stl | 713.5KB | |
| Pipe_Holder.stl | 877.0KB |
