In an attempt to reduce ghosting on prints, especially evident when printing at high speed, I have design a fully printed gantry support.
The support mounts to the gantry and base using existing screws (no modification to the printer required).
The parts are split to allow printing on a 220 x 220mm bed, and requires 12 self-tapping screws to assemble.
If you have the Creality LED Light Bar, there are alternative Cap files that include mounting provisions (Thanks to JasonBSB for testing these parts. You can see photos in the Make uploaded by JasonBSB).
| Arm_LH.STL | 1.6MB | |
| Arm_RH.STL | 2.5MB | |
| Base_LH.STL | 647.7KB | |
| Base_RH.STL | 648.9KB | |
| Cap_LH.STL | 2.3MB | |
| Cap_LH_Lightbar.STL | 2.4MB | |
| Cap_RH.STL | 2.3MB | |
| Cap_RH_Lightbar.STL | 2.4MB | |
| Foot.STL | 33.9KB | |
| Gap_Filler_1.6mm.STL | 15.1KB | |
| Gap_Filler_3mm.STL | 15.5KB | |
| Gap_Filler_6mm.STL | 15.5KB |
