X Axis camera mount to fit the Ender-3 V3 SE. I had the raspberry pi genuine camera but that died and I bought a new camera with IR lights. I really liked the x-axis mount I had from scottietrek though so I found a housing for the new camera by effixe and mashed it onto it. While I was there I moved the camera up and angled downwards to better capture flatter models.
You'll need four m3 x 10 machine screws. to join the two halves then it just slides on to the left (motor side) side of the x-axis.
Note: you might need supports under the two screw holes on the front panel. You can get away without it but if you're fussy this is the only bit that might need it.
| Ender-3V3SE-X-AxisIRCameraMount-Back.stl | 78.5KB | |
| Ender-3V3SE-X-AxisIRCameraMount-Front.stl | 202.5KB |
