Work in progress. Should function as is but it's far from ideal. Also remixed from a duct for a Sovol SV06, I will link to that when I remember where I downloaded it from originally. I think it was on Cults3D.

EDIT: https://www.printables.com/model/483474-sovol-sv06-fan-duct-5015-blower-fan-v3 that is the source of the duct part. They have a better one which I have on my SV06 now which screws up with supports on that printer.

I have not printed this version for my V3 SE yet, but i have used 2 which ended up being far too close to the print. I looked at the distances on my SV06 for the duct and edited this to be 2mm higher. The real issue i feel is the terrible angles on the side, I hope to make that more curvy, and also to try flattening the base so i can be printed without support, It has worked well in testing so far however, just far too low. I think the clearances should be ok even with PLA to avoid being melted by the heat block at the higher level, although I've yet to test this height. However it is on all 3 sides of the silicone cover on this printer and there is good distance between it. I maybe should have only adjusted 1mm though. I plan to test it in the next few days and i guess I'll know by the new year if it's not melting. I do have PETG but I'd rather test with PLA so it's easier for more people. Then I can try to make the pipe bit smoother