** Dec 2nd - V3 uploaded added space to properly fit the fans width and a bit more clearance elsewhere.
DONT Use other versions
* Dec 1st update. latest update.
Please wait for V3 which I will upload d3cember 2nd.
In the feedback from one of the makes I need to move the 5015 mount a couple mil to the right since the fan didn't have enough room to fit.
*** EDIT - Reports of bad first layer5... so i sliced in Prusa, CUra and Creality - all first layes seem good.
Will be giving this a try tomorrow.
** Uploaded a v2-..... just in case something was off with the orig stl
This is still not validated but its based off the two remixes noted below
This joins a lightweight OE Part cooler mount and 5015 blower fan
Print with OE FAN face place on the bed.
Need support just on the underside of the 5015 duct.
PETG as min, Probably ABS would be best due to proximity to bed..
https://www.thingiverse.com/thing:6332341
https://www.thingiverse.com/thing:6248194
| V2-Ender-3-V3-SE-Dual_Fan_Duct-5015-OE.stl.stl | 6.1MB | |
| V3-Ender-3-V3-SE-Dual_Fan_Duct-5015-OE.stl | 6.3MB |
