since i always use the creality print pc interface i never use the display, so I created a displayholder which safes some space, so it doesnt stick out.
It needed to fit next to the camera mount which I found on thingiverse.
I think it was this mount, but I am not sure: https://www.thingiverse.com/thing:6440000
It can be used with the original screws.
I had to pull the display cable a bit out of the case, connected it and then slid the display on the mount.
The supports are only needed under the tips of the slide on pins.
| Display_Halterung_29.2.2.stl | 78.0KB |
