A wire clip to hold the Z-Motor wire for the Ender 3 V2 and its predecessors. This clip will prevent the Bed Adjustment Knobs from catching on the wires during printing. While allowing you to keep the wire tucked away. Just one less unruly wire hanging on the outside of the printer!
The wire clip requries 1 3x0.5mm screw that is 6mm long. The clip is flexible to allow the wire to be inserted, but stiff enough to keep it secure.
Note: This is a relatively small part and should be printed at 100% infill. Print time is about 7-10 min. Recommended to watch the 2nd layer to make sure the curvature of clip adheres to the bed. If not, adjust the Z-Offset of the print.
I used PLA, but if you are concerned with motor heat, I recommend PETG.
If you have any questions, comments, or requests, feel free to contact me.
This is my own design, so feel free to contribute, share, and iterate!
| Z_Motor_Clip.gcode | 520.0KB | |
| Z_Motor_Clip.SLDPRT | 83.8KB | |
| Z_Motor_Clip.STEP | 49.3KB | |
| Z_Motor_Clip.STL | 68.8KB |
