I created a pi cam mount for my Ender 3 V2 that fits snuggly on the Y rail, while still giving you access to the Y Axis belt tensioner. The legs are angled slightly so it stays in place. Some double sided tape can be used for stability, but so far I haven't needed it.
You might need a 30cm or longer cable, depending on where you place your raspberry pi.
I created this to be as short as possible, without touching the build plate for smaller enclosures, such as the LACK enclosure. A longer one can be created if requested.
The camera enclosure I used was from https://www.thingiverse.com/thing:3188580 by austin3dprinting
Should fit Pi Cams V1, V2, and clones.
NOTE: This mount will only work on the Ender 3 V2 Version, as the other Ender 3 printers use a different Y rail.
Materials needed:
M3x15 screw (20mm or greater can be used as well)
M3 nut
| ender_3_v2_pi_cam_mount.f3z | 1.1MB | |
| pi_cam_body.stl | 98.4KB | |
| pi_cam_cap.stl | 19.0KB | |
| pi_cam_mount.stl | 51.0KB | |
| pi_cam_mount_70mm.stl | 50.8KB | |
| pi_cam_mount_75mm.stl | 50.0KB |
