The file 'Ender 3 V2 X-axis Level Guide 3D Printer Model' is (stl) file type, size is 2.1KB.
Noticed that my X-axis was much lower on one side than the other and thought that instead of using a ruler and constantly checking back-and-forth, why not print off a couple of guides.
Easy to use. I designed them to sit on the frame rails and clear the x-axis brackets, and wiring on the left side. Should just sit on the frame on the bottom, and the x-axis beam.
Print 2 of them, and put one on either side. The small block shaped tabs pop into the inside track of the vertical beams, and the flat side faces inward towards the bed. Then just loosen the brackets, set the x-axis down to rest on the two guides, and tighten.
EDIT v2. - Originally I had flares on either side to make the top/bottom wider but it was sitting on the middle section of the printer not the frame and sat a bit higher on one side as a result. I also shortened the design to 150mm from 200mm to save printing time. I also fixed a clearance issue with it hitting the left side bracket and I forced it out further so it sat on the beam not the belt.
X-axis_Level_Guide_150mm.stl | 10.0KB |