Printed with White PETG because this is the only white filament I have.
It will look better if printed with PLA.
I didn't put a fan in the design because I have modded the original 40mm controller fan with a 80mm fan, it pushes a lot of air through the vents, should also be able to cool down the Pi.
Fan Mods I used:
https://www.thingiverse.com/thing:4549738
https://www.thingiverse.com/thing:4548187
Camera Case I used:
https://www.thingiverse.com/thing:2987719
I soldered the USB2.0 D+ and D- directly on the controller board, as well as on my RaspberryPi 4. And connected a power wire from the PSU to a LM2596 to get 5V to power the Pi directly from its GPIO pins.
So I don't need to run any cable (except for the camera) outside the case.
The top cover is separated, so future mods can be done easily. I am planning to make another LCD screen into the top cover, for OctoPrint.
I have included the f3d design files so you can make changes and tweaks.
| Ender3V2_Box_THINGIVERSE.f3d | 4.1MB | |
| Ender3V2_Box_THINGIVERSE.stl | 455.4KB | |
| Ender3V2_Cover.f3d | 346.8KB | |
| Ender3V2_Cover.stl | 127.2KB |
