PLEASE, SEND ME A MESSAGE FOR ANY DOUBT/SUPPORT
This led light bar is taken the power from the internal source of your 3d printer.
Be careful! unplug the printer before any manipulation
Check the output voltage (24V) and confirm your led strip works in 24V (check picture)
The cables will be driven together with the data bus cable (the black and plain strip) (check picture)
The cables will be hidden in the Z profile: put the cables inside the aluminium profile, and hide with the 3p print "cableProfile". You will need 2 pieces to cover the full profile
For the arms, you will have to choice "switch" or "no switch" (see below the model of the switch), and only right arm is available: you will have to mirror the arm for the left side
Finally, for the bar of the led there are 2 choices: with crystal or without. In the case you are planning to print a transparent strip for the bottom, side, you need the top/bottom led. In you are planning to keep uncovered the the led strip, use the topLed (no glass) where the connector with the arms is wider
The led strip must be 24V
Follow this link to get the switches (out diameter 16mm): https://aliexpress.com/item/1005004608439621.html
NOTE: for the arms I used "tree" support
Good luck
| bottomLedGlass.stl | 8.5KB | |
| cableProfile.stl | 235.0KB | |
| rightArmLedNoSwitch.stl | 582.5KB | |
| rightArmLedSwitch.stl | 698.6KB | |
| topLedGlass.stl | 5.4KB | |
| topLedNoGlass.stl | 6.5KB |
