Ender 3 Pi Camera And Led Strip Mount With Ribbon Cable Attachment 3D Printer Model
The file 'Ender 3 Pi Camera And Led Strip Mount With Ribbon Cable Attachment 3D Printer Model' is (stl) file type, size is 256.2KB.
The file 'Ender 3 Pi Camera And Led Strip Mount With Ribbon Cable Attachment 3D Printer Model' is (stl) file type, size is 256.2KB.
I made another remix on this one, this time I wanted to be able to add LED strips. I had printed another LED strip holder which was mounted on the X gantry but it just blinded the camera and washed the picture out, so I wanted to make a light source coming from the same direction as the camera,
I also had a bit of an issue (could be with calibration) where the front was dropping off the camera holder so I added another point on top for an M3x6 screw to hold that on.
The top and bottom LED holders attach with some M3x10 screws. I made 2 versions of each, the shorter ones are for standard white LED's which I think can be cut to 50mm lengths, I made the longer ones because I only had RGBW ones which you can cut at 100mm and thought I'd use them so I soldered all of the RGBW connections to the negative and + to the positive. I also wired them in parallel because I'd used a buck converter to drop the voltage from 24 to 12. I suppose you could wire the top and bottom in series and attach to the 24 volt supply, I didn't want to do that.
I also had to adjust the position of the ribbon cable attachment because it was interfering with the bottom LED strip holder so there's a new one of those with this.
I printed all parts at 100% infill for strength, I tested 20% and snapped the connectors off when removing the support pieces.
| pi_camera_holder_with_led_strip_attachment_back.stl | 151.8KB | |
| pi_camera_holder_with_led_strip_attachment_bottom_long.stl | 194.6KB | |
| pi_camera_holder_with_led_strip_attachment_bottom_short.stl | 144.7KB | |
| pi_camera_holder_with_led_strip_attachment_front.stl | 68.0KB | |
| pi_camera_holder_with_led_strip_attachment_top_long.stl | 165.0KB | |
| pi_camera_holder_with_led_strip_attachment_top_short.stl | 145.6KB | |
| pi_camera_mount_with_ribbon_cable_attachment.stl | 176.7KB |
