This is a modified version the VORON Switchwire fan duct to mount it to a stock Ender 3.
I used two 4010 blower fans mounted back to back for cooling the part, and far the heat break it remains the stock 4010 fan.
You may find that mounting the blower fans its a bit harder because is tight fit, and when you mount the back blower fan you will need to run the wires under it from left to right.
You'll need suport only for Mount 1 and Mount 2.
Printing it in PLA works just fine, I recomande printing it in PETG just to be on safe side.
You will need:
6x 13mm M3
4x 10mm M3
3x 8mm M3
13x M3 Inserts
2x 4010 Blower Fan 24v
| Body_1.stl | 300.4KB | |
| Body_2.stl | 389.8KB | |
| Cover_1.stl | 545.9KB | |
| Cover_2.stl | 3.2MB | |
| Mount_1.stl | 90.8KB | |
| Mount_2.stl | 104.4KB | |
| Mount_3.stl | 332.9KB |
