Sorry for my English. I used a translator.
Thanks to the capacitor for the basis.
And then I will continue.
The fan mount has been redone so that when disassembling the bmg gearbox the cooling can be left alone.
Reduced height by 1.5mm for the bltach sensor
Added an extension for attaching wires.
The issue with M3x50 bolts has been resolved, now you can use the stock BMG mounting bolts.
Added extension for proper parking.
Assembly.
Needed for assembly.
6mm drill bit. Foam double-sided tape. a couple of plastic screws.
If you have a 22mm e3dv6 radiator it prints duck, if you have a 25mm radiator you print duck_25mm.
Material PETG ABS.
From PETG you print the radiator cooling fan mount and the main mount.
You print the fan mount from ABS.
The appendage will need to be heated and then slightly bent back so that it begins to put pressure on the end switch.
| CR10s_Mounting_Plate_BL_Touch.stl | 692.2KB | |
| CR10_BMG_Direct_Drive_Fan_Mount_with_insert.stl | 1.1MB | |
| Duct.STL | 257.4KB | |
| Duct_25.STL | 257.4KB |
