Ender 3 And 3 V2 Filament Guide – GO BIG – No Screws – No Supports 3D Printer Model
The file 'Ender 3 And 3 V2 Filament Guide – GO BIG – No Screws – No Supports 3D Printer Model' is (fcstd,stl,zip) file type, size is 3.3 MB.
The file 'Ender 3 And 3 V2 Filament Guide – GO BIG – No Screws – No Supports 3D Printer Model' is (fcstd,stl,zip) file type, size is 3.3 MB.
No supports
No Screws (all parts and installation are just a simple press fit)
The extra deep groove dominates even the most unruly of filaments!
STL and FreeCAD files provided
For Ender 3 and Ender 3 V2
The bracket is just a press-fit onto the z-carriage, with moderate effort until it is seated. Firmly push the bracket all the way onto the Z-axis carriage (the cutouts wrap around the axle spacer and nut).
The 2 half-rings are a press-fit onto the bearings. You can just use your hand, but I found that using a flat surface helps to press the parts nicely onto the bearing.
You will need a 608 bearing (one of the most commonly available bearings, used for skateboard wheels and other things).
When installing on the printer, make sure that the Ender 3 (or V2) nut has one of its flat sides at the top. This will give you the clearance for a nice snug fit.
UPDATE: To help with modifications, in addition to the FreeCAD (original) files, I've included STEP files.
| Bearing_Bracket_2020-12-09.FCStd-.FCStd |
| Filament_Guide_BIG_2020-12-09.stl |
| Half_Ring1_BIG_2020-12-09.stl |
| Half_Ring2_BIG_2020-12-09.stl |
| Ring_BIG.FCStd |
| STEP_Files.zip |
