Needed a latch with variable pressure for my enclosure, made this and it works good
The plexiglass was a bit flexible at some points throughout, so needed something to get a firm fit for the door so its air tight (not really air tight, but as good as I need it)
Made some different lenghts so you can get what fits best for you. I needed longer on the bottom, and smaller on the sides.
Used strong double sided tape on the plexi glass, and screw on the side, but thats up to you, made some holes for it so its easy to mount screws
| hook_lang_2_hull_fra.stl | 1.7MB | |
| hook_lang_2_hull_ner_.stl | 1.7MB | |
| hook_liten_1_hull_.stl | 1.8MB | |
| innside_hakk_steps_.stl | 226.3KB | |
| innside_hakk_steps_w_holes_.stl | 818.4KB | |
| lang_hook_hull_nede.stl | 1.6MB | |
| lang_null_hull_.stl | 1.6MB | |
| liten_med_2hull_ner.stl | 1.9MB | |
| liten_null_hull_.stl | 1.7MB |
