I created this because I wanted to install a RunCam Link digital FPV system on an old Emax Nighthawk 250 drone frame.
Install heat shrink tubing on the RunCam antenna if you need it to sit tight in the antenna holder. Print the antenna holder using brim.
Some of these parts were remixed from:
https://www.thingiverse.com/thing:5599338
https://www.thingiverse.com/thing:1655464
If you need a RunCam Link Vista replica to test placement, I recommend using:
https://www.myminifactory.com/object/3d-print-runcam-link-vista-263693
| 30mm_RunCam_19mmCamera_Holder.stl | 385.6KB | |
| 35mm_RunCam_19mmCamera_Holder.stl | 375.2KB | |
| Extra_Support_RunCam_Link_VTX_Holder.stl | 547.4KB | |
| Protector_35mm_RunCam_19mmCamera_Holder.stl | 424.2KB | |
| RunCam_Link_Antenna_Holder_30mm.stl | 147.2KB | |
| RunCam_Link_Antenna_Holder_35mm.stl | 141.3KB | |
| RunCam_Link_VTX_Holder.stl | 419.7KB |
