Elgato Ring Light Monitor Arm Mount 3D Printer Model
The file 'Elgato Ring Light Monitor Arm Mount 3D Printer Model' is (stl) file type, size is 17.9KB.
The file 'Elgato Ring Light Monitor Arm Mount 3D Printer Model' is (stl) file type, size is 17.9KB.
The Elgato Ring Light comes with it's own desk clamp and stand but with my existing monitor arms I had to mount it off centre and a little further back than I liked.
I design this cap to slide over top of the centre pole on my monitor arms and then you can re-use the pivoting clamp and mount that goes on top of the provided Elgato mount.
I printed at 100% infill and am hoping this will end up being strong enough.
The diameter of my monitor arms centre pole is 32.4mm. If that size doesn't work for you I suspect you can easily import this into TinkerCAD, lop off the bottom cylinder, add your own for your specific diameter and you're off to the races.
| Elgato_Ring_Light_Mount_v1.0_Partial.stl | 82.7KB |
