Elegoo Neptune 4 Pro Klick Klack Klicky Z-Probe 3D Printer Model
The file 'Elegoo Neptune 4 Pro Klick Klack Klicky Z-Probe 3D Printer Model' is (3mf,stl) file type, size is 799.9KB.
The file 'Elegoo Neptune 4 Pro Klick Klack Klicky Z-Probe 3D Printer Model' is (3mf,stl) file type, size is 799.9KB.
This one did not work for me:
https://www.printables.com/de/model/486559-elegoo-neptune-3-proplusmax-klackender-remix
Hard to find the right position. I wanted something flexible.
You need to print probe_mount_toolhead.stl and probe_block_left.stl from above project. I also copied in into this project for convenience.
(I did not try, but it might be worth mirroring the toolhead since the cable guide is on the wrong side.)
Probe wiring to the printhead: The bottom two pins (blue and black for me) are the signal and ground. Top pin is 24 volt! Leave that 24 volt pin open but protect the open wire (if you cut the original cable) against shorts. The headers on the breakout PCB are JST-PH size.
The retainer needs to be glued (I use thin double sided tape) to the tablet at the spot that matches for you.
Software: Klipper and dockable_probe module pull-request.
Documentation is really good. Just read, understand and try carefully to not run into your bed or something else.
Biggest benefit. You don’t have to change any macro.
I will try to keep this repo up to date (NO WARANTY!):
https://github.com/ProfDrYoMan/klipper
It is based on standard klipper master branch (https://github.com/Klipper3d/klipper) with the pull-request for the dockable-probe module (https://github.com/Klipper3d/klipper/pull/6247) merged into master.
| Klicky_Retainer.3mf | 212.0KB | |
| Klicky_Stopper.3mf | 89.5KB | |
| Klicky_Tablet.3mf | 165.0KB | |
| probe_block_left.stl | 546.1KB | |
| probe_mount_toolhead.stl | 610.8KB |
