This stand allows you to mount the build platform of an ELEGOO MARS 3D printer on the top of a food storage container (https://www.amazon.it/gp/product/B07856RRDW) used as a bath to wash your 3d prints by means of a magnetic stirrer (https://www.amazon.it/gp/product/B07GQDSBTT).
Link to the video: https://youtu.be/vCsdmmYyfOQ
In this way, you can wash the 3D printed objects leaving them attached to the build platform, thus avoiding direct contact of the prints with the walls of the container. Moreover, using a magnetic stirrer instead of an ultrasonic cleaner can avoid damaging the small details of your 3D prints and it allows you to use more safely the isopropyl alcohol as a cleaning liquid.
The container used in this project is large enough to allow the introduction of the build platform with objects as large as the entire build volume of the ELEGOO MARS.
By adjusting the height of the bracket you can use the right amount of cleaning liquid to wash the prints.
The assembly of the stand requires two 3.5x25mm screws and one M6x30mm or M6x40mm screw with nut and washer (https://www.amazon.it/gp/product/B07DNS312C).
To allow optimal rotation of the stir bar, I recommend to sand the small plastic bump in the centre of the bottom of the container.
| Container_Lid.stl | 118.4KB | |
| Container_Lid_no_inset.stl | 116.5KB | |
| Lid_Cover.stl | 41.3KB | |
| Platform_Holder.stl | 78.4KB | |
| Slide_Bracker.stl | 65.1KB | |
| Stir_Bar_Extender.stl | 175.1KB |
