Elegoo Mars Drawer Base W/front USB 3D Printer Model
The file 'Elegoo Mars Drawer Base W/front USB 3D Printer Model' is (stl) file type, size is 32.3KB.
The file 'Elegoo Mars Drawer Base W/front USB 3D Printer Model' is (stl) file type, size is 32.3KB.
Remixed to add a front USB to be used with a USB extension cable. Also adjusted to not require support attached to the print bed after I had a failure. To be printed with drawer openings facing the top.
Cable used: https://www.amazon.com/dp/B00N9HRTFU/
The USB fit may be just a touch loose. Mine was just snug enough to hold the extension in place when removing the flash drive.
Edit 12/19/19: Added appropriately-sized drawers (185x170x29) with finger cutouts rather than drawer pulls again to avoid support.
Edit 3/25/20: Added alternative with 1cm taller openings to accommodate height of spare vats with lids and FEP-protecting bases. Added taller drawers to match
| Copy_of_Mars_Base_USB_Deep_Drawers--Tall.stl | 57.0KB | |
| Copy_of_Mars_Base_USB_Deep_Drawers.stl | 56.4KB | |
| Mars_Base_Deep_Drawer.stl | 8.5KB | |
| Mars_Base_Deep_Drawers--Tall_no_dividers.stl | 8.5KB | |
| Mars_Base_Deep_Drawers--Tall_with_dividers.stl | 10.0KB | |
| Mars_Base_Deep_Drawer_Divided.stl | 10.0KB |
