I got several of the old Sentinel kits and am designing variants that in my opinion would make sense. This here is an electronic warfare variant.
Regarding the parts:
"Comm_array" is intended to go into the upper position of the sentinel where the powerpacks usually go. You can either use the "Comm_array" and add your own antennas, combine the Comm array with your choice of "Antenna1-4" or use "Comm_array with antennae".
"Sat_dish_top" is intended vor the roof of the armored Sentinel variant.
"Drone_jammer" is meant to be magnetized (a 3x2 mm magnet should fit) and put at the position where there are usually the weapons.
"radom base" goes behind the door, where this little box part is usually glued. You can either add "radom top" immediatly or stack 1-3 "drone_ports" there, as indicated in the pic. I will try this as I have a set of three small drones from Anvil Industries that I want to combine with this model.
26.09.2024: upon printing and building it I have to admit: all the stuff together on the same sentinel looks just too much. I recommend leaving out the comm array and either leave the side mount open or fix an infantry Vox-pack there.
| Antenna1.stl | 247.5KB | |
| Antenna2.stl | 389.5KB | |
| Antenna3.stl | 1.1MB | |
| Antenna4.stl | 29.2KB | |
| Comm_array.stl | 5.5MB | |
| Comm_array_with_antennae.stl | 7.2MB | |
| Drone_Jammer.stl | 5.0MB | |
| drone_port.stl | 3.1MB | |
| radom_base.stl | 141.5KB | |
| Radom_top.stl | 31.3KB | |
| Sat_Dish_Top.stl | 9.5MB |
