Electronic Dice enclosure for DIY Dice Soldering Project from "The Electronics Kit Shop"
www.electronicskitshop.com
Basic 2 part box with glue on spots to make it look like a dice on the outside the lid is a snap fit in to the main body of the box. There is a switch hole to the rear of the box and just enough room to fit a 9volt battery diagonally below the circuit board. The STL files appear to make it look like the box is solid but for some reason when i drew them it orientated them this way, Once in your slicing software you will need to orientate it the correct way
Feel free to make this better if you can i have only a very basic knowledge of using drawing software. The Dice spots i made to be 12mm in diameter although cura seems to make them huge when i inserted them into the software.
Link posted below to actual dice kit used.
| Part_Studio_1_-_Part_1_6.stl | 39.9KB | |
| Part_Studio_1_-_Part_2.stl | 17.1KB | |
| Part_Studio_1_-_Part_3.stl | 56.7KB |
