see updates for more info!
feel free to continue this project, i think i will go the Metal mount route ^^
motor mount to be used with caliber 2 / 50° trucks.
this is is designed to work with a "Turnigy Aerodrive SK3 - 6374-192kv Brushless Outrunner Motor". will probably work for motors with similar size as well.
update 20.05.2017
It broke after the first 6.5km, i reinforced the area (near the clamp) and printing it now.
update 21.05.2017
i added a support clamp for the other side to transfer some of the vibration energy over there. did a 16km ride and had another minor crack on the outside of the clamp in one of the screw holes where the motor is mounted. the inside (opposite side) however was perfectly fine which means only the outer 6 layers broke. reprinted with 100% infill (still PETG)
update 25.05.2017
ok this does not realy work. on smooth surfaces its not a problem, but it will break sooner or later when hitting bumpy roads. i tried thickening it to a point where its just no viable anymore.
| mount-short-support.stl | 98.5KB | |
| mount-short.stl | 150.7KB |
