Electric Skateboard Front & Rear Lights 3D Printer Model
The file 'Electric Skateboard Front & Rear Lights 3D Printer Model' is (stl) file type, size is 327.1KB.
The file 'Electric Skateboard Front & Rear Lights 3D Printer Model' is (stl) file type, size is 327.1KB.
I deigned some front and rear lights for my electric skateboard. I've used this on a Slick Revolution cruiser deck.
I've used 10mm led strip, WS2812B and you can get 12 pixels a long the bar. I've put a channel down the back so you can run small wires to the leds, the channel goes from both sides and there is a gap in the middle for cables to exit.
I've got some Arduino micro controllers for changing the lights. e.g. brighten the rear light to red for braking and different light modes. I've just copied different Arduino codes of the web to try and make it work. I won't add the code as its not very good.
I've glued the bar down using epoxy glue.
Some YouTube videos the might help with code.
Ionut Fedaceag --- https://www.youtube.com/watch?v=cia5Xr7aA0c
Ionut Fedaceag --- https://www.youtube.com/channel/UCfl3oOwTOWcAQSc3KsgFGbA
| Bracket_Wide_v5.stl | 882.8KB |
