This project was inspired by the firefly remote https://www.thingiverse.com/thing:2454391.
Because we had no VESC but only ESC for RC/cars we had to change
the project a little. I printed mostly in black PETG but also PLA or ABS is possible.
We made a fully 3D-printed case for the ESC's, batteries and electronics.
Its made in smaller components so it can be printed on a regular size 3D-printer.
There are holes and pins for sliding the parts together.
The case is based on the boosted board.
Added the battery cover with hinge (you can use bike wire for axle).
I added a speedometer on a wheel with a hall-sensor and magnet in the wheel.
There is a holder within the files to mount the hall-sensor.
Changes for the firefly remote:
1 - the trigger was a bit to big because i switched the place of the arduino and the nRF24 transmitter
2 - the controller plate for arduino and nRF24 is changed to clip the arduino and transmitter
so you can better load the software on the arduino usb port.
Parts list:
If you make something I appreciate if you post a picture of it.
| Arduino_box1.stl | 1.0MB | |
| Arduino_box2.stl | 51.4KB | |
| Battery_box1b.stl | 183.9KB | |
| Battery_box2.stl | 194.5KB | |
| Battery_box3.stl | 247.6KB | |
| Battery_fix.stl | 100.8KB | |
| Battery_top.stl | 231.9KB | |
| Case_Pin.stl | 94.0KB | |
| Controller_plate1.stl | 70.8KB | |
| ESC_box.stl | 243.6KB | |
| ESC_box_front2.stl | 275.3KB | |
| ESC_box_top.stl | 596.0KB | |
| ESC_plate2.stl | 97.5KB | |
| Firefly_ESC.ino | 20.7KB | |
| Hall_bracket1.stl | 65.6KB | |
| Hall_bracket2.stl | 246.0KB | |
| Longboard.ino | 5.4KB | |
| Scharnier1.stl | 175.0KB | |
| Trigger2.stl | 165.2KB |
