Recommended: Print with flat surfaces facing down on the build plate.
Minimum Recommended Print Settings:
– Supports: Enabled
– Support Type: Tree supports
– On Build Plate Only: Enabled
– Threshold Angle: 20
Note for Threshold Angle: You can increase this number to add more supports. A setting of 20 may leave slight imperfections inside the egg, but it doesn’t seem to impact sound quality. A setting of 35 or higher will create too many supports, which are difficult to remove.
| Egg_Shaker_-_Large_-_Bottom.stl | 3.6MB | |
| Egg_Shaker_-_Large_-_Top.stl | 3.8MB | |
| Egg_Shaker_-_Medium_-_Bottom.stl | 3.6MB | |
| Egg_Shaker_-_Medium_-_Top.stl | 3.8MB | |
| Egg_Shaker_-_Small_-_Bottom.stl | 3.6MB | |
| Egg_Shaker_-_Small_-_Top.stl | 3.8MB |
