I have been looking for an egg holder that meets all the following requirements:
Because I didn't find such a model, I designed it myself.
A single holder measures 50x100mm and holds two eggs.
Several holders can be connected together in a very stable way.
The printing time for a single holder (two eggs) is almost exactly one hour, 16g filament are needed (@my printer/configuration).
Up to four holders can be easily positioned on a 200x200mm heatbed and thus printed in a single job.
The eggs must have a maximum diameter of at least 35mm in order not to slip through the holder.
If necessary, the parameters can be adjusted in the Customizer.
To remove a single egg, lift it from the bottom with a finger.
BTW: For a secure stand, at least two holders should be connected to each other.
| Eier-Lager.scad | 1.9KB | |
| Eier-Lager.stl | 565.9KB |
