The file 'EE Electrical Breadboard Cabinet Stackable Case – Parts – UPDATED Control Panel And Cabinet Wall Support 3D Printer Model' is (stl) file type, size is 27.8KB.
I have seen an assortment of Breadboards, Blocks, Cases, etc.
I have not yet found something that I found useful enough to be comfortable with, besides the Foldable Breadboard / Arduino Cases - which I also designed & printed my own versions of.
This seemed to fulfill the needs that I commonly look for:
This Control Panel is setup for mounting:
Assembly requires the: BreadboardTrayFloor , 2 Drawers , 2 StdCtr Parts , 2 StdSide Parts , 1 CntlPnl - and GlueGun suggested.
The 2 StdSide Parts are glued under the sides of the Tray - as side Legs.
The Drawers are individually temporarily slid in to adjust and glue in the StdCtr Parts, in the center bottom of the Tray - as Center Legs.
The CntlPnl is glued onto the rear of the Tray.
When dry, the Drawers can then be slid back in.
For the TENTACLE PROBES , see:
Also these are Stackable.
To stack them, you can either mount the StackLegs on the Board sides individually, or buil a Cabinet to slide the Tray-Drawer Boards in.
To create a shelf, mount the multiple StackLegs vertically to desired height , then horizontally via a bottom shelf with the SupportFloorWall Part and in the rear with another SupportFloorWall Part.
Then slide the Boards into the Shelves.
Hope this is useful !
| MA_BRDBRDBOX_BreadboardTray_Floor_172x66x7_0013b_.stl | 4.6KB | |
| MA_BRDBRDBOX_Cabinet_SUPTFloorRrWall_176x61x1_0026c_.stl | 5.0KB | |
| MA_BRDBRDBOX_CntlPnl_PotSwiLeds_37x170x25_017d_.stl | 94.6KB | |
| MA_BRDBRDBOX_Drawer_67x81x13_014a_.stl | 7.1KB | |
| MA_BRDBRDBOX_StackLeg_RoofSupt_Med_81x10x44_020d_.stl | 8.3KB | |
| MA_BRDBRDBOX_StdCtr_67x10x23_016a.stl | 2.2KB | |
| MA_BRDBRDBOX_StdSide_67x10x23_015a.stl | 2.2KB |
