Edited Walls And Slide/Cutter For Wrap Holder 3D Printer Model
The file 'Edited Walls And Slide/Cutter For Wrap Holder 3D Printer Model' is (stl) file type, size is 149.4KB.
The file 'Edited Walls And Slide/Cutter For Wrap Holder 3D Printer Model' is (stl) file type, size is 149.4KB.
I wanted to be able to grab the film from the sides rather than from the front, so I cut a hole for that.
Then I found the original cutter was a little too tall, so I cut the original one down.
Then I decided to design a slider mount for the cling wrap slider blade.
I have run into the issue that my slider blade track is a little too wide, so i had to nip off a little at either end.
| Edited_Side_Wall_Left.stl | 65.3KB | |
| Edited_Side_Wall_Right.stl | 65.3KB | |
| front_door_2holes-Fixed_part_1.stl | 81.4KB | |
| front_door_2holes-Fixed_part_2.stl | 81.4KB | |
| front_door_2holes-Slider_part_1.stl | 56.7KB | |
| front_door_2holes-Slider_part_2.stl | 53.1KB | |
| front_door_3holes-Fixed_part_1.stl | 94.4KB | |
| front_door_3holes-Fixed_part_2.stl | 94.3KB | |
| front_door_3holes-Slider_part_1.stl | 60.8KB | |
| front_door_3holes-Slider_part_2.stl | 81.3KB |
