This is a clock for the wonderful Flying Tourbillion Model 1.5 escapement by A26. These parts are unmodified by me, but added here for completeness:
12tesc-3
balancewheel
framea-3
spring-3
roller-3
anchor-3
A26 offer various ways to make the tourbillion and you should refer to his thing page for that. It also uses modified gears from his other clock as well.
IT should run for about 6 hours, or how ever many times you can wind the string around the drum because that's one hour per wind. To rewind it, just pop off the tourbillion and wind up the string and then set the time again. Sure, it will engage the gears as you wind it, but it doesn't take long to rewind and does not involve taking apart very much of the clock.
You will need:
a 608ZZ ball bearing
3mm stainless steel metal rods
about one meter of string.
This is an advanced clock which is frustratingly hard to get right. Please be prepared for much tinkering if you expect it to run for any length of time.
UPDATE: I've added a cap that goes on the top of the clock hands rod. This should help hold those gears in place so they don't slip forward. I've printed mine in flexible filament.
| 12tesc-3.stl | 476.3KB | |
| anchor-3.stl | 255.5KB | |
| balancewheel.stl | 484.0KB | |
| EB_Tourbillion_Clock_-_Frame_Bottom.stl | 115.1KB | |
| EB_Tourbillion_Clock_-_Frame_Top.stl | 41.3KB | |
| EB_Tourbillion_Clock_Cap.stl | 85.5KB | |
| EB_Tourbillion_Clock_Hour_Hand.stl | 22.2KB | |
| EB_Tourbillion_Clock_Minute_Hand.stl | 21.0KB | |
| EB_Tourbillion_Clock_Pennyweight.stl | 36.5KB | |
| EB_Tourbillion_Clock_Pennyweight_Top.stl | 63.8KB | |
| EB_Tourbillion_Clock_Roman_Numerals.stl | 182.4KB | |
| EB_Tourbillion_Clock_Wheel_2.stl | 256.2KB | |
| EB_Tourbillion_Clock_Wheel_3_Drum.stl | 626.4KB | |
| EB_Tourbillion_Clock_Wheel_4_No_Drum.stl | 1.2MB | |
| EB_Tourbillion_Clock_Wheel_5.stl | 303.8KB | |
| EB_Tourbillion_Frameb3_Bottom_Platform.stl | 68.9KB | |
| EB_Tourbillion_Frame_Bottom.stl | 41.8KB | |
| EB_Tourbillion_Frame_Top.stl | 205.4KB | |
| EB_Tourbillion_Gear_and_Shaft.stl | 53.4KB | |
| framea-3.stl | 756.5KB | |
| roller-3.stl | 97.6KB | |
| spring-3.stl | 2.3MB |
