Update:
added an explanatory picture as the term "leveling" seems to cause misunderstandings.
Bed-Leveling allways was a nightmare to me. I payed a lot of attention when I first assembled my printer, i leveled everything, starting with the desk where i built the machine on it.
But i allways had problems once everything was assembled or if everything was fine and i had to move my machine i had to start all over again...
So while i could bring it down to a point where i could print "smaller" parts i recently printed parts that needed the WHOLE printbed-area.
So i decided to put a finger on my problem which seemed to bee the 2 Y-Axis Guides not beeing 100% parallel and square, and to adjust this i designed these replacement for the fixed Smooth-Rod holder.
I got feedback on my version 01 and i wanted to address these inputs before i hit the 1'000 downloads mark so here it is.
Changes:
| bed_leveling_kit_v02.3dm | 2.7MB | |
| complete_v02.stl | 1.7MB | |
| fixed_distance_v02.igs | 314.9KB | |
| fixed_distance_v02.stl | 365.7KB | |
| main_v02.igs | 1.7MB | |
| main_v02.stl | 303.4KB | |
| slider_v02.igs | 669.8KB | |
| slider_v02.stl | 117.1KB |
