New Version Available!!!
http://www.thingiverse.com/thing:63796
Bed-Leveling allways was a nightmare to me. I payed a lot of attention when I first assembled my printer, i leveled everything, starting with the desk where i built the machine on it.
But i allways had problems once everything was assembled or if everything was fine and i had to move my machine i had to start all over again...
So while i could bring it down to a point where i could print "smaller" parts i recently printed parts that needed the WHOLE printbed-area.
So i decided to put a finger on my problem which seemed to bee the 2 Y-Axis Guides not beeing 100% parallel, and to adjust this i designed these replacement for the fixed Smooth-Rod holder.
| bed_leveling_set.stl | 3.4MB | |
| constant.igs | 213.2KB | |
| constant.stl | 686.5KB | |
| main.igs | 1.9MB | |
| main.stl | 2.2MB | |
| slider.igs | 713.3KB | |
| slider.stl | 522.2KB |
