This is a earrings holder that allow to store more than 200 different earrings (it depends by floors quantity).
Roof can store in the internal part also necklaces.
It possible to use holes, vertical rod or slots to secure your earrings.
Colums are designed with different height: from 100mm to 50mm. for each floor you have to print No 4 Colums with the same height and No 4 bars. Columns can be stacked with a male/female joint. Horizontal bars are locked with colums. Base plate has also four containers. Rotating base plate needs to be fixed with a 608RS bearing.
After mounting horizontal bar can be secured with Closing Pin, you need No 8 Closing pin for each floor.
| Base_plate_r2.stl | 256.2KB | |
| Closing_PIN.stl | 13.6KB | |
| Column_100mm.stl | 27.8KB | |
| Column_50mm.stl | 31.7KB | |
| Column_60mm.stl | 31.7KB | |
| Column_70mm.stl | 30.2KB | |
| Column_80mm.stl | 30.2KB | |
| Column_90mm.stl | 28.6KB | |
| Earring_holder_bar.stl | 207.9KB | |
| Necklaces_Roof.stl | 284.1KB | |
| Rotating_Base.stl | 334.8KB |
