UPDATE 4/8/19
Shortened height of part cooling fan due to reports of it being too long.
A very compact, clean-looking, sturdy adapter to put a E3D v6 hotend on your Anycubic Chiron. Uses all Stock Chiron mounting holes as well as fans with no drama. Extruder board relocated to the side which gets rid of strain (you dont have to hot glue it like the stock position!).
Part cooling shroud is to be just glued on.
hardware needed:
(2x) m2x8
(2x) m3x30
(8x) m3x12
(3x) m3x6
The bed level sensor wire is not long enough with this upgrade, but can very easily be extended with a soldering gun and some extra wire.
Designed mainly for SLA/DLP printing in mind but should work with a well dialed-in FDM printer no problem.
| Adapter_V2_main_body.STL | 1.1MB | |
| Cooling_cover.STL | 459.8KB | |
| fan_shroud3.STL | 377.5KB |
