I have integrated the fan duct mount into the titan extruder mount to have the whole item as a single part rather than another separate spacer as my screws were not long enough for both.
Also i included the duct and inductive sensor mount i used in my setup. I needed this part as i could not fit the rear mounted fan as it was hitting the side of the frame of my printer.
| contraption1.stl | 378.3KB | |
| fan_adapter_50mm_r3.stl | 1.3MB | |
| fan_duct_lhs_v3.stl | 611.6KB | |
| titan_x-carriage_sensor_mount.stl | 314.5KB |
