The file 'Dungeon Stairs And Doors 3D Printer Model' is (stl,thing,zip) file type, size is 20.2MB.
Like a lot of folks, I prefer the lower-detail "Dungeon Tiles for Miniatures Gaming" by Telvin_3d over the lumpy-bumpy floors of the OpenForge Tiles.I created a couple of doors and "stair" elements to use with the system. The .stl sizes are a bit wonky, but if you rescale everything to be 50mm in the z-direction, the pieces should fit perfectly with the originals.
This was a pretty quick build, so the edges and alignments aren't super-clean and consistent, but it's good enough for my purposes.
| Dungeon_Door.stl | 1.6MB | |
| Dungeon_Door.thing | 434.3KB | |
| Dungeon_Rough_Opening.stl | 2.8MB | |
| Dungeon_Rough_Opening.thing | 673.3KB | |
| Dungeon_Stairs.stl | 7.6MB | |
| Dungeon_Stairs.thing | 1.8MB | |
| Dungeon_Stairs_Turn.stl | 9.3MB | |
| Dungeon_Stairs_Turn.thing | 2.2MB | |
| Stairs_and_Doors.zip | 10.8MB |
