Duet Wifi Configuration For TronXY X5S 3D Printer Model
The file 'Duet Wifi Configuration For TronXY X5S 3D Printer Model' is (g,stl,stp) file type, size is 165.3KB.
The file 'Duet Wifi Configuration For TronXY X5S 3D Printer Model' is (g,stl,stp) file type, size is 165.3KB.
READ CAREFULLY!
This is MY configuration for the TronXY X5S for the Duet Wifi controller board.
Because it's MY configuration i can not gurantee it will work with yours.
My setup: (Capital written words = potentially problem area, you may have to adjust in config)
TronXY X5SA (same as X5S but stock with other controller board and some addons)
BLTOUCH AUTOLEVEL SENSOR
Bondtech extruder with PENCAKE STEPPER (More steps than stock)
SINGEL Z DRIVE (More steps than stock)
Filament run out sensor (should be no problem if you don't connect one)
Some more hardware things which should not be problematic
For wiring the duet you should take a look into the documentation:
https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams
For wirirng the bltouch take a look at:
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe
Also take a look at my mods for the X5S:
https://www.thingiverse.com/thing:3206802
https://www.thingiverse.com/thing:3206767
https://www.thingiverse.com/thing:3206779
If you have some helpful tips or website please share them with the others.
Thank you for donations
| bed.g | 805.0B | |
| config.g | 5.8KB | |
| deployprobe.g | 188.0B | |
| DuetCover.stl | 62.6KB | |
| DuetCover.stp | 259.0KB | |
| Duet_Wifi_Board_holder.stl | 237.4KB | |
| Duet_Wifi_Board_holder.stp | 349.1KB | |
| homeall.g | 1.1KB | |
| homex.g | 519.0B | |
| homey.g | 519.0B | |
| homez.g | 572.0B | |
| retractprobe.g | 190.0B |
