DualShock Yoke For Flight Simulators 3D Printer Model
The file 'DualShock Yoke For Flight Simulators 3D Printer Model' is (stl) file type, size is 608.6KB.
The file 'DualShock Yoke For Flight Simulators 3D Printer Model' is (stl) file type, size is 608.6KB.
Snap-together yoke adapter for your playstation dualshock controller. No other hardware required.
See the video to see how to put it together: https://youtu.be/ylIe6uNZf6c
It will explain how to get good tolerance and sliding motion.
It is important to print the parts in the orientation shown in the screenshot. Especially the shaft, the bushing and the slate must be printed this way to slide well.
No support is required.
Perhaps you would also like my joystick adapters for PS4 and Xbox etc.: https://www.thingiverse.com/thing:4618312
And my arduino stand-alone joystick: https://www.thingiverse.com/thing:4576634
To clamp the yoke down, I used this awesome 3D printable clamp: https://www.thingiverse.com/thing:1673030
| base.stl | 211.0KB | |
| base_shaft_slate.stl | 684.0B | |
| bushing.stl | 52.8KB | |
| dowel_print_2.stl | 23.9KB | |
| dualshock_mount.stl | 270.3KB | |
| joystick_collar_print_2.stl | 210.6KB | |
| pitch_linkage_a.stl | 246.3KB | |
| pitch_linkage_b.stl | 284.2KB | |
| pitch_linkage_c.stl | 105.1KB | |
| roll_linkage.stl | 233.1KB | |
| rotary_shaft.stl | 121.0KB | |
| shaft.stl | 114.7KB | |
| shaft_rubber_band_fork.stl | 1.4KB | |
| small_dowel_print_2.stl | 21.8KB |
