Dual Pixel Arch Mount 3D Printer Model
The file 'Dual Pixel Arch Mount 3D Printer Model' is (stl) file type, size is 173.8KB.
The file 'Dual Pixel Arch Mount 3D Printer Model' is (stl) file type, size is 173.8KB.
This is a dual end point (two PEX pixel arches meet at this point) yard mount for RGB PEX pixel arches for Holiday Decorators. This mount is held to the ground with two tent stakes (spikes) and a tie wrap is tied around the top portion of the mount to the PEX to keep it in place. A single mount is also listed here for the end points of the run of arches. These were built from standard PLA with 20 - 25% infill and held up nicely through out the winter. The only one that got broken was from the snow thrown on it during the extremely heavy year of snow - (worst in almost 50 years). Fast and easy to set up. The slot in the side is for the wire to slide through at the end of the arch. Very happy how these turned out.
*NOTE** A flaw was pointed out in the original file. I have uploaded a revision..
| Dual_Arch_Mount_RevA.stl | 193.7KB | |
| light_arch_dual_mount.stl | 280.2KB |
