This is a wall mounted dual 3ds XL charger, just slip your charge cables through the holes (carefully trimming the plastic on the chargers to ensure a snug but not loose fit), and use hot glue (low temp preferred) to keep it in place. Run the wires through the channels, then mount to wall.
This is best printed with the back printed on the bed.
Version 1.2 has some voids inside, saving about .1 lbs of plastic.
| DUAL_3ds_holder_1.0.stl | 104.4KB | |
| DUAL_3ds_holder_1.1.stl | 138.1KB |
