This was an idea I had when I realized that my desk was pretty cluttered with stuff that I used pretty regularly and was sick of looking at just hanging out. (A gaming mouse, charging cables, glasses cloth, etc. etc.)
This is a four part system. The two "selves" slide into one another allowing for them to be a single structure and offering the most support in the center where the monitor is most likely to stand. The walls of these prints are 10mm thick, so they should be pretty sturdy. The footprint of the structure is 500mm wide, and 250mm deep. The photos illustrate it holding a 24" Acer monitor which weighs about 7 lbs (3.2 kgs). And it holds it with no issue. The drawers are tall enough to hold a decent amount of stuff.
When you print these parts print them with the flat side down. I designed them in such a way that when printed that way they require NO supports.
Please feel free to use this as you see fit, and modify it as you see fit. :-)
| Monitor_Drawer.stl | 15.1KB | |
| Monitor_Shelf_-_Left.stl | 4.6KB | |
| Monitor_Shelf_-_Right.stl | 4.6KB |
