Dual Dock Charging Station For Apple Watch And IPhone 3D Printer Model
The file 'Dual Dock Charging Station For Apple Watch And IPhone 3D Printer Model' is (stl) file type, size is 317.8KB.
The file 'Dual Dock Charging Station For Apple Watch And IPhone 3D Printer Model' is (stl) file type, size is 317.8KB.
This is a multi-function dual dock charging station for an iPhone and an Apple Watch.
It has been tested with an iphone and an iphone plus, with and without protection case. Even it have been tested with a book-like cover on an iphone 7 and it fits.
To place the watch charger, pass the USB end through the front hole from the outside to inside the case. Then press gently the charger until it sits on the hole.
You can coil both USB cable on the inside to keep it organized while charging or during travels.
If you insert the cover on the groove located at the central column, it acts as a support for the iphone when it is charging.
If you lay the case on a lateral side, it can act as a watch stand, as you can see on the pictures.
I printed it on PLA without any support. Infill at 5% is enough.
Hope you enjoy it!!!
Comments are welcomed.
| Apple_Dual_Dock_base.stl | 850.3KB | |
| Apple_Dual_Dock_cover.stl | 34.4KB |
![Minimalistic Phone Stand [STL, STEP] 3D Printer Model](https://res.3axis.co/5869bc6d-0fec-46c7-82fe-e232cc63815b/images/a4c1f530-865f-477c-90e1-e01709461f5f_thumb.jpg)
