(sponge) drying rack I originally designed as a rinsing container for stirring magnets used in labs thus the small holes for water drainage which will let rice grains trough but no macaroni just to give you an idea.
I chose to design it as an assembly so there are no need for supports and printing these designs flat on the bed gives good results. And because of this it fits a longtype-envelope(110mm, 220mm)
Dimensions assembled piece:
lenght:190mm.
width: 103mm.
height: 45mm.
The design is a precise fit so try not to overflow the filament by high temperatures/increasing flow rate. It could cause the fittings to be bigger/fitting holes to be smaller resulting in a difficult assembly.
If you have any questions, or even if you feel I should give you more information please do tell/ask This is my first post so please enlighten me if you can.
| drying_rack_part_1.stl | 816.0KB | |
| drying_rack_part_2.stl | 687.9KB | |
| drying_rack_part_3.stl | 349.0KB |
