Dryer Sheet Dispenser 3D Printer Model
The file 'Dryer Sheet Dispenser 3D Printer Model' is (stl) file type, size is 55.7KB.
The file 'Dryer Sheet Dispenser 3D Printer Model' is (stl) file type, size is 55.7KB.
Hai!!
Are you like me, and constantly have junk all over every horizontal service of everywhere in your house? My solution is to wall-mount EVERYTHING!! I'm sick and tired of a basket of laundry knocking my box of dryer sheets off the side of my clothes dryer and behind other stuff. I could declutter, I could sort the closet...
but I've got a 3D printer and ADHD, so I'm going to use the tools I have.
Anyway, what was I talking about?
Right!
This bottom-dispensing unit fits about 175mm by 110mm sheets, and the full model is 200mm high, holding about 400 (bounce) sheets. My little Kobra Neo had a failure halfway through and it didn't complete, but even a half-print works fine!
The full model takes 125.63mm of filament, 374.70g. My little guy would have taken 10hr37 to print the whole thing. I used 3 wall loops, 5% adaptive cubic infill, 0.32mm layer height, and 0.3mm first layer. Oh! Combination Infill, as well.
No supports needed, I'd print it with a 10mm skirt, and a good dollop of hairspray to ensure good bed adhesion.
Take it, print it, sell it, remix, whatever. I just wanna give back to the community that's given me so much.
Hope you like it!
| Dryer_Sheet_Dispenser_-_001.stl | 282.7KB |
