Drybox 2x1kg Ikea 365+ 10.6l 3D Printer Model
The file 'Drybox 2x1kg Ikea 365+ 10.6l 3D Printer Model' is (stl) file type, size is 1.8MB.
The file 'Drybox 2x1kg Ikea 365+ 10.6l 3D Printer Model' is (stl) file type, size is 1.8MB.
dry box for 2 filament rolls up to 1kg (per roll) - in an IKEA 10.6 liter box. the filament is guided and unrolls evenly to the last turn.
it is now possible to completely manufacture the drybox, with only 6 screws, 2 nuts and the rest are printed parts.
the filament take-up can be closed when not in use to preserve the silica.
look at the pictures for the correct assembly of the filament guide.
round hygrometers are available by mail order (amazon etc.).
look at the additional info for installing the rolls.
Intended for smaller printers from 165mm (split basis).
with lid for the silica box (the screws are not required).
there are hose holders with and without fittings
• with fittings:
guide_box_inside
fitting_guide_outside
fitting_end_plug
spacer_ikea365
• without fittings:
guide_box_inside
guide_box_outside
end_plug
V2: 10 bearings 608 are required.
V3: new rolls - no bearings.
as a shaft you can use your own material (158mm) or print the shaft that is included here. for the loads, which are at max 2.5 kg and max one revolution per minute, the rollers and shaft printed are sufficient.
the filament_guide can be printed without support, but brim is needed.
all parts can be printed without support - turn on the bridge setting (cura).
| box_ikea365.stl | 562.5KB | |
| end_plug.stl | 116.0KB | |
| filament_guide_inside.stl | 154.1KB | |
| fitting_end_plug.stl | 164.5KB | |
| fitting_guide_outside.stl | 140.3KB | |
| guide_box_inside.stl | 137.1KB | |
| guide_box_outside.stl | 72.3KB | |
| LID_Ikea365.stl | 478.4KB | |
| rolls_holder_1.stl | 195.4KB | |
| rolls_holder_2.stl | 287.6KB | |
| shaft_ikea365.stl | 23.0KB | |
| spacer_ikea365.stl | 20.8KB | |
| v2_roll.stl | 1.9MB | |
| V3_rolls_no_bearing.stl | 411.8KB | |
| washer_ikea365.stl | 68.8KB |
