This is a update of the "FireFlo v2" and a remix of the "DragonFli" frame (yes... with "i"!) and an alternative frame for the Blade NanoQX (also FPV).

Some general details:

• It consists of a topplate and a lowerdeck connected with shock absorbers to undock the flight control + cam and reduce motor vibrations.
• It has higher stiffness then the v2
• There are different options and predefined strapholders to attach the lipo (on the topdeck or under the lowerdeck)
• Antenna protection predrills
• More free space to add your own vTx and cam and enough space to place different flight controls (from NanoQx original board to SciSky).
• And because it consists of two parts, you can now mix colors yeyyyy!! :D

Some more detailed details:

• It fits the original NQX Cam or the additional Spektrum Micro Cam or selfmade cams.
• Its available for 7mm and 8.5mm Motors.
• You can bend the camera holder up to 20° if you heat it up a bit, but be careful.
• Frame size is at ~110 mm diagonal (m2m) and about 9 x 9 cm in length and width.
• Frame weighs ~7.3g (depending on the material used).
• You will need 3x shock absorbers

Example Setups that will fit and are tested:

Shock Absorbers:

• 50g camera gimbal damper rubber anti-vibration shock absorber

Motormounts:

• Motor holders for this frame can be found here: https://www.thingiverse.com/thing:1133331

Antenna Protection:

• Just use two cable ties and put them in the provided holes in the lower deck (see screenshots)

Motors 7mm:

• micro-motor-warehouse.com: CL-0720-12, CL-0720-14
• Standard Hubsan x4 H107L

Motors 8.5mm:

• micro-motor-warehouse.com: CL-0820-15, CL-0820-17 Dark Edition
• Standard Hubsan x4 H107D, H107C

Flight Control:

(for a proper fit, you should remove the motor plugs and solder the motors directly to the board):

• NanoQx Board (MOSFETs need to be replaced when using 8.5mm motors)
• NanoQx FPV Board
• MicroMWC (MOSFETs need to be replaced when using 8.5mm motors)
• SciSky

Cam and vTx:

• NanoQx FPV Cam
• Spektrum Ultra Micro FPV CAM SPMVA1100
• Selfmade like this: http://flitetest.com/articles/diy-micro-5-8ghz-fpv
  (but if you get this to fit, its more like a bumblebee then a firefly ;) )
  Get the "Bumblebee Backpack" here: http://www.thingiverse.com/thing:1134205

Rotors:

• Standard Hubsan x4
• Standard Revell Atomium

Energy:

• I recommend these for a flight duration of about 5-7min depending on your style and motors: 1s 3,7V 500mAh
• Velcro to strap it (10mm)

If you have questions, don't be shy. :)