The file 'Drip Tip/Vape Cap – Display Protectors – TF-RTA / TFV4 / TFV8 / TFV12 / Dead Rabbit / Athena / Gnome / Fuchai / Custom 3D Printer Model' is (stl,f3d) file type, size is 1016.6KB.
I bought a display stand on FastTech for my atomizers, and quickly realized they build up a lot of dust just sitting on display on a shelf, so I whipped up these quick caps to protect the insides so I won't have to clean them too much if I decide to swap back to an older tank and to keep them looking nice.
The TF-RTA seems to be a standard 510 but is shorter than the TFV4
The TFV4 seems to be a standard 510
The TFV8 and TFV12 are the same size, and seem to be standard 810
The Dead Rabbit is for the Dead Rabbit RDA by HellVape & Heathen
The Athena is for the Athena Squonk RDA by GeekVape
The Gnome is for the Gnome RTA by Wismec
The Fuchai is for the Fuchai Squonk RDA by Sigelei
The TFV8 cap also fits the TFV12 since they use the same size drip tip.
The Fuchai has sloped sides and the cap is a bit of a press fit, but does fit. If I were to design it again I would add an extra 0.5mm for added tolerance/clearance.
Will upload a photo in a little bit :).
| AthenaCap.stl | 39.7KB | |
| DeadRabbitCap.stl | 39.3KB | |
| FuchaiCap.stl | 47.2KB | |
| GnomeCap.stl | 38.9KB | |
| TFRTACap.stl | 55.3KB | |
| TFV4Cap.stl | 53.2KB | |
| TFV8Cap.stl | 47.0KB | |
| Vape_caps.f3d | 1009.5KB |
