Since I don't always want to use power tools to rework a hole, I was looking for a hand tool. I found inspiration at Rasle500, thing:16682 and at aubenc, thing:16839. But the models did not suit me in the present form, they were too clumsy for me. A further weakness were the stuck collets, after one screwed tight.
Therefore I designed a completely new holder, where only the collets are compatible.
The holder is slimmer and has a diameter of 32mm and a length of 96mm. It also has an ejector that allows you to release tightly fitted collets with a light tap.
As always, the thread needs a few passes until the unevenness caused by the printing is smoothed off.
Printer Settings:
Material: PLA
Resolution: 0.2mm
Wall thickness: 1.2mm
Infill: 50%
Support: no
Adhesion: Brim
Recommended by me:
Box for Drill Holder and Collets by Syntaxcuemi. This is a very nice addition to my drill holder.
| clamping__nut.stl | 665.2KB | |
| Collets.FCStd | 1.4MB | |
| Collet_d2.5.stl | 146.4KB | |
| Collet_d3.0.stl | 175.7KB | |
| Collet_d3.5.stl | 159.2KB | |
| Collet_d4.0.stl | 119.1KB | |
| Collet_d4.5.stl | 114.0KB | |
| Collet_d5.0.stl | 146.6KB | |
| Collet_d5.5.stl | 141.9KB | |
| Collet_d6.0.stl | 166.4KB | |
| Collet_d6.5.stl | 160.8KB | |
| Collet_d7.0.stl | 108.3KB | |
| Collet_d8.0.stl | 159.8KB | |
| DrillHolder.FCStd | 1.3MB | |
| ejector.stl | 260.2KB | |
| handle.stl | 780.9KB |
